Interfacing Chromatography to NMR

Hyphenated analytical techniques combining mass spectrometry and chromatography are well established laboratory tools. The combination of chromatography and NMR has also made its way into the analytical laboratory. Further developments even combine all three techniques into an LC-NMR/NMR-MS system and the introduction of solid phase extraction as efficient interface between chromatography and NMR. In principle, two different main workflows are possible.

L C Schema

The chromatography system can be coupled more or less directly to the NMR spectrometer. The sample is transferred into the NMR “as is”, that is, it arrives with the concentration and the solvent as supplied by the chromatography system. The sample can be transferred during the chromatographic separation and the NMR spectra are then acquired either in on-flow mode (continuously, while the chromatography is running), alternatively the NMR spectra are acquired under static conditions. For this purpose a selected peak is parked in the NMR probe and the chromatography is paused (stop-flow). Alternatively the peaks are intermediately parked in sample loops and transferred to the NMR after the end of the chromatographic separation (loop-storage transfer).

In the latest development in LC-NMR, solid phase extraction cartridges are used to immobilize selected peaks after the chromatographic separation. The chromatography solvents are removed and the samples are eluted with fully deuterated solvents from the cartridges into either an NMR flow probe or into standard NMR sample tubes.

The standard trapping/elution process on an SPE cartridge already provides a concentration of the sample that leads to a 100% sensitivity gain compared to LC-NMR. In addition the chromatography can be repeated to multiply the sample content of the cartridge prior to the elution into the NMR. This easily supplies enough material for more demanding inverse experiments or the detection of very low concentrated compounds.

The Bruker LC-SPE-NMR system provides a dramatic increase in signal-to-noise of the NMR spectra by sample concentration. This makes it ideal for full structural elucidation with more demanding inverse experiments, or for the investigation of low concentrated impurities. Furthermore, the fully deuterated elution solvents provide standard conditions for the acquisition of NMR spectra.

LC-SPE-NMR system is therefore the system of choice for detailed investigation of individual peaks from chromatographic separations. For screening purposes chromatography can be connected to a flow probe. A dedicated interface is not required.

LC NMR system

Connection to the NMR Probes - Flow Probes and CryoFit

For the NMR measurements of a directly coupled LC-(SPE)-NMR/MS systems a flow probe is required. Bruker has developed a variety of high-resolution NMR flow probes with unique sensitivity and NMR configurations like normal 5mm NMR probes (.i.e. inverse and TXI geometry Z Gradients, ATMA, etc.). They have a build in flow cell, that is available in different sizes.
CryoProbes™ provide a dramatic increase in sensitivity by a factor of 3-4 in tube operation mode. Bruker offers a CryoFit™, which converts any standard 5-mm CryoProbe or a CryoProbe Prodigy into a flow probe. The conversion takes only a few minutes and is done while CryoProbes is in the magnet and cooled. No downtime for warm up/cool down required.