Service-training-banner.jpg

DektakXT

Feb 20-21, 2019 | Karlsruhe, Germany

Course Objective:

During this modular 2-day course you can improve your skillset on the Bruker Dektak XT system. If you are new to the system or need a refresher, you can choose to stay the two days or participate only in one or two days, depending on your personal requirements. The course covers basic software usage, Stylus selection, Stylus installation, alignment, standard experiments in N-Lite and Safe mode on the first day. A brief look into the analysis functions is also scheduled for day one. On the second day advanced options of the DektakXT are covered. We would start with Calibration, Automation programs, Database setup and Roughness Measurement. The course will be held in Karlsruhe, Germany. The language will be English.

The course will be held in Karlsruhe, Germany. The language will be English.

Day 1:

  • Introduction to Dektak Profilometry
  • Vision64 software
  • DXT Measurement set up
  • Vision64 software
  • Stylus and Force selection, Calibration, Step Measurements
  • Basic Analysis functions

Day 2:

  • Artifacts
  • Optimizing scan parameters
  • Automation programs and Database
  • Roughness Measurements

Registration

Register

Cost and Conditions

  • One free seat for Standard Care customers
  • Two free seats for Premium Care customers.
  • Standard fee 500 Euros per day.
  • Daily lunch is included.
  • Application deadline closes 4 weeks before the training begins.
  • The maximum number of participants is 6, when there are more than 6 participants we will try to organize an extra training.
  • When less than 3 participants register, the course will be cancelled.